Sharkbite Fitting Removal - Getting Started / Wireless Flow Meter - Rachio Community
Sharkbite Fitting Removal
post by TCMan on Aug 11, 2019
Anyone know how to remove a Sharkbite fitting from a flow meter? I had to replace a malfunctioning flow sensor, but the Sharkbite fitting removal tool I bought only worked on the copper pipe, not the PVC side of the fitting (diameter was too large for the tool).
post by tmcgahey on Aug 12, 2019
This should work on the IPS side (IPS is slightly larger than copper).
post by TCMan on Aug 12, 2019
Yes the disconnect tool worked on the copper side so I was able to remove the flowmeter and Sharkbite fittings from the irrigation line. But the tool did not work for removing the Sharkbite fittings from the flowmeter. Any ideas for the flowmeter side of the Sharkbite?
post by tmcgahey on Aug 12, 2019
That tool I posted should work…the copper pipe side is slightly smaller OD than the IPS side of the flow meter.
post by TCMan on Aug 12, 2019
OK thanks – I’ll give it a try. Very inexpensive!
post by TCMan on Aug 22, 2019
OK - I received the Sharkbite PVC tool today, and unfortunately it does not fit. The shoulder diameter of the flowmeter is too large for the tool.
post by ProWater on Aug 25, 2019
Great question! As you need to push in the release collar and there isn’t much space.
I have three flow meters to install and was wondering the same things as I always like to be prepared in the field.
Have you found anything suitable to improvise removal by this time?
post by TCMan on Aug 25, 2019
Yes I have the tool you have ordered. It works for removing the flow meter plus Sharkbite fitting assembly from the copper irrigation line, but it will not work for removing the Sharkbite fittings from the flow meter. This means that if you need to replace the flowmeter you will need to buy two new Sharkbite fittings at a cost of $19 each.
post by rexm on Nov 28, 2020
I am having same problem. There is not enough room for any tool. Any ideas. I hate to spend another $40 for new sharkbites.
post by rexm on Nov 28, 2020
I got it. I took small screw drivers and pushed out white a little, then bigger one until I got real large ones and pushed off the darn thing… A little beat up, but worked perfect when re-used.