Adding support for Flomec

post by Knutsont on Jun 8, 2022

This info is from a previous thread, but I just installed a QS200-15 that I would like to use. Would it be possible to add support for this (these) flow meter(s), please?

Additionally, could a generic meter model be added in which the user could input arbitrary k-factor and offset?

All Flomec models:

• QS200-15
  K = 0.7926
• QS200-20
  K = 1.3765
• QS200-30
  K = 3.8444
• QS200-40
  K = 7.1676

All have an offset of 0.

Thanks.

post by edfetzer on Aug 18, 2022

Slight correction to the above based on the latest published Kfactors from the Flomec Website…

Flomec Data Sheet (see page 2)

• QS200-15
  K = 0.7923
• QS200-20
  K = 1.4610
• QS200-30
  K = 4.2630
• QS200-40
  K = 8.0881

All have an offset of 0.

I would also like to request that the QS100-10 flow sensor be added to the flow sensor selection in the Rachio app. I have this meter installed on my system with a Rachio controller, but the readings are not correct because it is not currently supported in the app.

The QS100-10 has the following Kfactor and Offset.

QS100-10 Data Sheet (see page 2)

• QS100-10
  K = 0.4211
  Offset = 0

In lieu of any additional specific manufacturers and models being added to the app, I would be in strong favor of adding a generic flow sensor where the user can enter their own custom K factor and Offset values.